Exploded Views are used to show the assembly sequence of parts in the assembly. The located parts in the assembly with the help of the constraints are set
You can create mirrored symmetric versions of the parts and components (sub-assemblies) in the NX assembly modeling. The “Mirror Assembly” command is used to
You can change the projection angle of the technical drawing in the NX drafting from the drafting standards or at the start of the sheet. If you want to change
You can pattern components in the assembly by defining target points or coordinate points in the assembly. To create a general pattern in the assembly.
QuickPick helps you to select one of the objects on the way of the mouse cursor that perpendicular to the NX screen. These objects change due to NX applications
In the assembly modeling, some of the parts in the assembly navigator might have shaded color. When you try to make these parts visible by clicking the checkbox
This problem occurs because of the wrong settings selection in the command dialog box. You can not edit these texts after created in the NX modeling. You should
In some of the tutorial notes or books, you can see the MMB shortening. Also, it is my favorite shortening that I use in my posts frequently. But I see that
RMB is the shortening of the computer component that you can see in some books or tutorials about pc programs or computers. I also use the RMB shortening
You can see the LMB shortening in some of the books or tutorials about pc programs. Also, I use this shortening very often in my tutorials in the blog. It is
