Auto dimensions created automatically in NX, during curves created in the Sketch application.
These auto dimensions might cause performance problems in large
Read More Auto Dimensioning in NX
Month: September 2020
You can change the side of the “Resource bar” on the left or right side of the NX screen.
The Resource Bar includes:
Assembly Navigator
Constraint Navigator
Read More Changing Resource Bar side in NX
Changing Resource Bar side in NX
There are different ways to change sketch names in NX. You can both change sketch names outside the sketch or inside the sketch (sketch created by using “Sketch
Read More Naming Sketches in NX
Naming Sketches in NX
Because there might be visibility problems because of reference set settings of the components in the assembly modeling. (Datums, curves, sketches in the
Read More Reference Set Visibility in Part Navigator
Reference Set Visibility in Part Navigator
Browser command in NX shows relations between features of the model in a newly opened dialog box.
You can start browser command in different ways.
Read More Browser Command in NX