You can create centerlines on the center of the circles by using the “Centerline Drop-Down” commands in the NX Drafting. To activate Centerline commands:
You can move the section line to after the section created on a model view in NX Drafting. To move section line: Click twice on the section line. Move the
In some of the conditions creating a dimension on a circular object that specifies a tangent point might be a problem. The reasons and solutions of this problem
You can change the text orientation and location on the existed dimensions in the NX Drafting. And also you can change this setting for the new dimensions.
You can change the existed dimension extension line attached point in NX Drafting. The dimension value will be changed according to the new assigned point on
In SolidWorks, editing features like Fillet and Chamfer modify solid body edges, while Draft and Shell adjust faces. Designers often apply these at the modeling
You can create mid-lines between two existing curves in the NX Sketch by using the “Derived Lines” command. To create a mid-line on the center of the two lines
In the NX Sketch, The “Ellipse” command is used to create ellipses. To activate the “Ellipse” command in a sketch: Menu => Insert => Sketch Curve => Ellipse
The “Scale Curve” command scales the selected curves in the NX Sketch. There are two methods in the command to scale curves. Dynamic Method: Scales the curves