You can create mid-lines between two existing curves in the NX Sketch by using the “Derived Lines” command. To create a mid-line on the center of the two lines
Read More Creating a mid-line between two lines
Month: October 2021
In the NX Sketch, The “Ellipse” command is used to create ellipses. To activate the “Ellipse” command in a sketch: Menu => Insert => Sketch Curve => Ellipse
Read More Ellipse in NX Sketch
Ellipse in NX Sketch
The “Scale Curve” command scales the selected curves in the NX Sketch. There are two methods in the command to scale curves. Dynamic Method: Scales the curves
Read More Scale Curve in NX Sketch
Scale Curve in NX Sketch
The “Delete Curve” command is used to remove curves in the NX Sketch. To delete curves in the sketch: Start the “Delete Curve” command. Select the curves to
Read More Delete Curve in NX Sketch
Delete Curve in NX Sketch
You can change the size of the chamfers dimension by using the “Resize Chamfer Curve” command in the NX Sketch. To change chamfer size: Start the “Resize
Read More Resize Chamfer Curve in NX Sketch
Resize Chamfer Curve in NX Sketch
The “Resize Curve” command changes the diameter/radius of the circles, arcs, or fillets in the NX sketch. You can change the selected multiple curves at the
Read More Resize Curve in NX Sketch
Resize Curve in NX Sketch
“Offset Move Curve” command offset the selected curves at a specified distance in the NX sketch. The command might change the curves that are not selected if
Read More Offset Move Curve in NX Sketch
Offset Move Curve in NX Sketch
Move curve command is used to move or rotate (can move and rotate at the same time) the selected curves in the NX sketch. The dimensions on the curve are
Read More Move Curve in NX Sketch
Move Curve in NX Sketch
Synchronous commands are used to edit existing curves in the NX Sketch. The modified curve relations change or remove due to modification applied to the curves.
Read More 2D Synchronous Commands in NX Sketch
2D Synchronous Commands in NX Sketch
You can rename sketches in NX modeling during sketch creation and after the sketch was created. Methods to change sketch names: Sketches Created by the “Direct
Read More Renaming Sketch in NX Modeling