The significant changes made in the Note command with the new NX version. (NX 2206) The “General” tab opens in the “ Ribbon Bar” when you start the “Note”
Read More Creating Drafting Note in NX CR 2206
Month: September 2022
In NX Drafting, the datum leader location is fixed on the selected object during the datum creation. You can move the datum leader outside of the selected
Read More Moving Datum Arrow Outside in NX
Moving Datum Arrow Outside in NX
You might have a problem while inserting GDT symbols to the Notes, Dimensions, or Feature Control Frames in the NX Drafting. Also, some of the GDT symbols
Read More GD&T Symbol Problem in NX Drafting
GD&T Symbol Problem in NX Drafting
CF letters in a hexagon symbol are used on dimensions or tolerances in technical drawings to specify “Continuous Feature” in the technical drawings as shown
Read More Continuous Feature Symbol
Continuous Feature Symbol
Spotface is nearly similar to counterbores but there are some differences between them. Spotfaces specify clean and flat surfaces for the
Read More Spotface in Technical Drawings