You can create text in the 3D model in the Siemens NX Modeling application. Text can be created: on a plane at a specified point, direction, angle on a curve on
Read More Text in Siemens NX Modeling
Month: September 2023
You can create splines by using existing points, or by creating new reference points in NX. There are two different studio spline-creating methods in Siemens
Read More Studio Spline in Siemens NX Modeling
Studio Spline in Siemens NX Modeling
You can create Circles by using the “Arc/Circle” command in NX Modeling. If you want to create a circle change the setting in the dialog box as shown in the
Read More Creating Circle in 3D Siemens NX Model
Creating Circle in 3D Siemens NX Model
You can create Arc by using the “Arc/Circle” command in the 3D model. To create Arc: Start the “Arc/Circle” command. (The command location on the “Curve Ribbon
Read More Creating Arc in 3D Siemens NX Model
Creating Arc in 3D Siemens NX Model
You can create straight lines out of sketches in NX modeling. These lines can be created: between two points, between a point and tangent of a circular curve or
Read More Line in NX Modeling
Line in NX Modeling
You can create a points pattern on a face in Siemens NX Modeling as shown in the figure. To create a point-set pattern on a Face: Start the “Point Set” command.
Read More Points Pattern on Face in NX
Points Pattern on Face in NX
If you create a spline in NX Modeling, you can create points on the spline. The points will be created at the location where the points are used to create a
Read More Creating Point on a Spline Curve in NX
Creating Point on a Spline Curve in NX
You can create a point set that is arranged at an equal distance on a curve or edge in NX Modeling. For this operation, the “Point Set” command is used. The
Read More Creating Point Set on a Curve in NX
Creating Point Set on a Curve in NX
In NX Modeling, You can create points on snap points of the geometry (associative or non-associative), defined coordinates, and defined distance from an object.
Read More Point in NX Modeling