Siemens NX

Bounded Plane

You can create a surface from the set of connected curves by using the “Bounded Plane” command. The “Bounded Plane” command is nearly similar to the “Fill Surface” command. But you can remove the specified region inside the sheet surface.

To create a surface by using the “Fill Surface” command:

  1. Start the “Bounded Plane” command.
    (Surface Ribbon Bar => Surface Group => More => Bounded Plane)
  2. Select the curves to specify a region.
  3. If you want to remove a region from inside the surface, select the curves that specify the region.
  4. Click the middle mouse button to finish the command.

Leave a Reply

Your email address will not be published. Required fields are marked *