Tag: Curve Group
-
Make Corner
You can make corners between curves in the sketch of the NX. If both curves intersect, the curves are trim to make a corner. If the curves do not intersect,
-
Polygon
You can create “Polygon” in the sketch. You can change the number of sides of the polygon. To create “Polygon” Start the “Polygon” command in the sketch
-
Curve on Surface
Draws spline curve on surface To activate command: Curve Ribbon Bar => Curve Group => Curve Gallery => Curve on Surface Menu => Insert => Curve =>
-
Project Curve
To activate command: Curve Ribbon Bar => Derived Curve Group => Project Curve Menu => Insert => Derived Curve => Project Curve For Using “Project Curve”
-
Studio Spline
Creates spline through defined points. You can change positions of points or drag points while the command has been activated. You can create 3D splines