In NX drafting, the created line curves with the same dimension sizes might be seen as different sizes as shown in the figure. This problem occurs because of
You can add or remove tolerances to dimensions in NX Drafting. To add or remove the tolerances click on the drop-down arrow as shown in the figure and select
You can see whether the sketch is fully constrained or not in Siemens NX. A fully constrained sketch means all curves and points in the sketch are fixed by
You might have a problem while inserting GDT symbols to the Notes, Dimensions, or Feature Control Frames in the NX Drafting. Also, some of the GDT symbols
In NX drafting, You can show dimensions both in imperial (inch) and metric (mm) systems. You can convert existing dimensions or create new dual dimensions.
Dimension arrowhead direction can be changed both during dimension creation and after the dimension is created. To change dimension Arrow-Head direction during
In some of the conditions creating a dimension on a circular object that specifies a tangent point might be a problem. The reasons and solutions of this problem
You can change the text orientation and location on the existed dimensions in the NX Drafting. And also you can change this setting for the new dimensions.
You can change the existed dimension extension line attached point in NX Drafting. The dimension value will be changed according to the new assigned point on
