It simplifies faces by merging, improving, deleting faces.
Sometimes in complex parts, it increases the PC performance.
I mostly use this command to optimize
Read More Optimize Face
Tag: Home Ribbon Bar
Select Faces to move when “Select Face” highlighted in Face tab
Select “Motion type” to move. (Distance-Angle and Point to Point most used motion types)
Read More Move Face
Move Face
You can delete faces on the model by using the “Delete Face” command.
There are four types in “Delete Face” command
Face
Blend
Hole
Blend Size
Read More Delete Face
Delete Face
You can change the radius of the blend faces on the model by using the “Resize Blend” command.
The center of the cylindrical face changes, after the command
Read More Resize Blend
Resize Blend
You can pattern curves to defined points by changing “Layout” as a “General” in the “Pattern Definition” tab.
To make General Pattern:
Read More General Pattern
General Pattern
You can pattern curves around point by “Circular Pattern” in Pattern Curve command
Change “Layout” as a “Circular” in the
Read More Circular Pattern
Circular Pattern
You can pattern curves through one or two linear directions by “Linear Pattern” in "Pattern Curve" command
Change “Layout” as a
Read More Linear Pattern
Linear Pattern
Pattern Curve is used for patterning curve-curves in the sketch.
Note: If you have a selection problem change curve rule on top bar shown in the figure
Read More Pattern Curve
Pattern Curve
You can change hole diameters by using the “Resize Face” command. The circle center stays constant.
Command activation: Click on
Read More Resize Face
Resize Face
You can create a new parent assembly for the current part or assembly.
Command activation:
Select New parent command from
Read More Create New Parent