The sheet size can be changed before after the sheet is created in NX drafting. To change sheet size: Start the “Edit sheet” command. To start this command.
The sketch x, y-axis can be changed or reversed, during sketch creation in NX. To set new axis directions for the sketch creation Start the sketch command.
There are different methods to change the background color in NX Drafting. But there are some limitations. You should change the object colors which color
The java error is the most common Siemens NX installation problem. Different java errors might occur but there is one solution for all of them. The Java
WCS is shown on the Datum coordinate system when creating a new part in NX. It can not hide by any commands in the NX. You should use a specific command to
You can show or hide tabs of the resource bar in NX. If you can not see the tabs of the resource bar, probably you hide these tabs. To show or hide the Resource
Resource Bar shows tabs as Assembly Navigator, Part Navigator, History, Web Browser, Roles, etc.… You can show or hide tabs in the Resource bar if you need it.
By the default NX settings, sketches are seen on screen and part navigator. There are two different methods to hide sketches. You can hide or completely remove