Category: NX CR 2206

In NX modeling, You can create a helical spline curve through a vector/straight line or a splined curve. The created helical splines might have a constant or

You can create text in the 3D model in the Siemens NX Modeling application. Text can be created: on a plane at a specified point, direction, angle on a curve on

You can create splines by using existing points, or by creating new reference points in NX. There are two different studio spline-creating methods in Siemens

You can create Circles by using the “Arc/Circle” command in NX Modeling. If you want to create a circle change the setting in the dialog box as shown in the

You can create Arc by using the “Arc/Circle” command in the 3D model. To create Arc: Start the “Arc/Circle” command. (The command location on the “Curve Ribbon

You can create straight lines out of sketches in NX modeling. These lines can be created: between two points, between a point and tangent of a circular curve or

You can create a points pattern on a face in Siemens NX Modeling as shown in the figure. To create a point-set pattern on a Face: Start the “Point Set” command.

If you create a spline in NX Modeling, you can create points on the spline. The points will be created at the location where the points are used to create a

You can create a point set that is arranged at an equal distance on a curve or edge in NX Modeling. For this operation, the “Point Set” command is used. The

In NX Modeling, You can create points on snap points of the geometry (associative or non-associative), defined coordinates, and defined distance from an object.