Setting new part default folder for NX

New part default folder settings for NX is “C:\Program Files\Siemens\NX 11.0\UGII\” (it might be different for some computers)

For changing the default folder of the new part

1- Click the right mouse button on the NX icon. Then click properties. The new part folder is in the “Start in” bar.

2- For changing this new part start folder; copy your folder address which you want to use for part saving files.

3- Paste folder address to “start in” box in properties of the NX icon. Then click ok or apply button.

4- Also you can change the new part folder from the new part box when click for a new part.  (The picture below). But you should be careful because sometimes it might reset itself to the default folder setting.