Finding Component Constraints in NX

You can find a selected component constraint in NX Assembly.

The figure shows the selected component constraint in the constraint navigator.

To find constraints related to a selected component:

1. Click on the “Constraint Navigator” on the Resource bar.
   
2. Right-click on the empty area in the “Constraint Navigator”.
3. Select “Group by Components” in the opening list.
4. The constrained components will be listed in the “Constraint Navigator”. Their constraint is listed under them.
5. Select a component in the NX graphics window.
6. In the “Constraint Navigator”, the selected part will be highlighted.
7. Click on the “+” near the highlighted part.
8. The constraints list will be open related to the selected component as shown in the figure