Polygon

You can create polygons that have different numbers of sides in Solidworks sketch.

To create a Polygon:

1. Start the Polygon command. (Placement of the Polygon command shown in the figure)
2. Set the numbers of sides for the polygon in the polygon command property manager.
3. Click on the graphics window to place the center point of the polygon.
4. Click on the graphics window to specify a point on the circumstance to create a polygon.

You can create a polygon both inside or outside of the circle. To change the circle side, change the checkbox near the “Inscribed circle” or “Circumscribed circle” after the polygon created.