- Draw sketch of both plates on xz plane
- Click on revolve command to revolve sketch.
- Select created sketch as section
- Select the “z” axis to revolve the body. The point will be selected automatically
- Set end angle in the limits tab as a 360°
Draw sketch of rubber on xz plane
- Click “Intersection Curve” and select the face shown on the figure.
- Draw the curve of rubber by using a profile command.
Click on revolve command to revolve sketch.
- Select created sketch as section
- Select the “z” axis to revolve the body. The point will be selected automatically
- Set end angle in the limits tab as a 360°
- Select the Boolean type as “none”. (It is your choice to make none or unite. But if you select none, 3 body will be created. And you can change the color of each body)
- Type” Ctrl+J” and select the body to change color.
Leave a Reply