Draft

Changes face angles through defined references.

To activate command:

  • Click command on Home Ribbon Bar => Feature Group => Draft
  • Click command on Menu => Detail Feature => Draft

For using “Draft” command:

  • Activate the “Draft” command.
  • “Draft” command window will open. “Specify Vector” in the Draw Direction” tab will be highlighted automatically.
  • Define vector. The defined vector will be the angle start vector.
  • Click the middle mouse button lightly. The second tab will be activated.
  • Define Stationary faces when “Select Stationary Face” highlighted in the second tab.  These faces will be used for fixing edges of the drafting faces.
  • Click the middle mouse button lightly. The third tab will be activated.
  • Define “Faces to Draft” when “Select Face” in the “Faces to Draft” tab highlighted.
  • Type angle for the draft or drag angle arrow on the screen.
  • If you want to change the direction of the draft, Click on “Reverse Direction” in the “Draw Direction” tab. (Also you can drag arrow angle to opposite side or type minus “-“ before angle value)
  • Double click (MMB) or click on “Ok” in the command window to finish command.

Leave a Reply

Your email address will not be published. Required fields are marked *