NX 11

Studio Spline

Creates spline through defined points. You can change positions of points or drag points while the command has been activated. You can create 3D splines freely.

To activate command:

  • Curve Ribbon Bar => Curve Group => Studio Spline
  • Menu => Insert => Curve => Studio Spline

For Using “Studio Spline” command:

  • Activate the “Studio Spline” command.
  • Define “Type” settings as “Though Points” or “By Poles”
    • Though Points: Spline curve lies through points
    • By Poles: Spline curve does not lie through points
  • Select point locations.
  • Arrange degree of a spline in the “Parameterization” tab.
  • Click the middle mouse button or “Ok” to finish.

Leave a Reply

Your email address will not be published. Required fields are marked *