Example: Move Face

  1. Start the “Move Face” command.
  2. Select face to move
  3. Change “Motion” type as “Point to Point” in the Transform tab
  4. Select the motion start point when “Specify From Point” highlighted. (If it is not highlighted, click MMB once to activate this tab or select manually this tab)
  5. “Specify To Point” tab will be highlighted automatically.
  6. Click on the point to move feature.
  7. The model will be updated if there is no problem to move face.
  8. Click “Ok” to finish.

Note: You should be very careful when using this command. In this example, the start and the endpoints are on a similar planar face. That’s because the height of the face didn’t change. 

Leave a Reply

Your email address will not be published. Required fields are marked *