Siemens NX

Repositioning Sketch Origin in NX

You can relocate the sketch origin after the sketch created. 

To change the position of the created sketch origin:

  1. Activate the sketch. (Click twice on the sketch to edit and activate the sketch)
  2. Click on the “Reattach” command. Reattach Sketch command dialog box will open.
    Home Ribbon Bar => Direct Sketch Group => More => Reattach
  3. Click on the drop-down arrow near the “Fix” icon in the “Sketch Origin” tab
  4. Select “Inferred Point” and specify a new origin point.
  5. Click “Ok”

Note: If you want to move sketch origin point to work part origin. “Set the Origin Method” as “Use Work Part Origin”

Leave a Reply

Your email address will not be published. Required fields are marked *