Siemens NX

Specifying a Coordinate of a Point in NX

You can learn the coordinate of a point by using the “Measure” command.

Before selecting the point, You should change the “Object to Measure” setting as a “Point” in the command dialog box. Then select a point to see coordinates. The coordinate information will be seen in the graphics window after a point selected.

Note: The result will disappear from the graphics window after the command closed. If you want to be seen the result permanently in the graphics window, click on “Display Annotation” from the “Measure” dialog box. Also, you can select “Display Annotation” on the “Measure” result box in the graphics window.

Leave a Reply

Your email address will not be published. Required fields are marked *